FREE · PRIVATE · INSTANT

Trex-Style Composite Decking Calculator

Trex-Style Composite Decking Calculator estimates brand-neutral composite deck boards for planning grooved or square-edge composite decking. Enter job dimensions in U.S. customary units, adjust supplier assumptions, and get purchase-ready quantities instantly.

Loading calculator…

HOW IT WORKS

Formula and assumptions

Divide deck width by board width plus gap, divide each course by stock length, then apply waste and round boards up.

Boards run along the entered deck length.
Stock boards and joists are assumed straight and usable.

FIELD CHECK

Before you order

This calculator is not affiliated with a manufacturer; use the selected system's board dimensions, approved spans, clips, and installation guide.

Worked example

Example: with deck length 20 ft, deck width 16 ft, actual board width 5.5 in, board gap 0.25 in, the trex-style composite decking calculator returns 39 boards for deck boards. The supporting check is joists: 16 joists. Replace the prefilled measurements and supplier assumptions with the project values before ordering.

PROJECT GUIDE

Using this calculator well

WHEN TO USE IT

Best use of this calculator

Use the result as a planning estimate, then verify field measurements and product-specific data before ordering or building.

INPUTS EXPLAINED

What each input means

Deck length: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Deck width: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Actual board width: Enter the measured value and choose the matching unit (in, ft, cm, mm).
Board gap: Enter the measured value and choose the matching unit (in, ft, cm, mm).
Stock board length: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Joist spacing: Enter the measured value and choose the matching unit (in, ft, cm, mm).
Fasteners per board-to-joist intersection: Enter the project value used by the calculation.
Fastener allowance: Enter the project value in %.
Waste allowance: Enter the project value in %.
Price per deck board: Enter the project value in $.

COMMON MISTAKES

Checks that prevent bad estimates

Mixing units or entering a measurement in a different unit than the selected field unit.
Using a planning default when the exact manufacturer or supplier specification is available.
Rounding intermediate measurements too early instead of rounding the final purchase quantity.
Ignoring waste, compaction, cuts, laps, settlement, or full-package rounding where the project requires them.

SOURCES & REVIEW

How this estimate is supported

The implemented formula, assumptions, and worked example on this page are the calculator-specific reference. BuildYard's broader rules are documented in the Calculation Methodology and Sources & References.

For material density, coverage, yield, dimensions, package quantity, price, and other product-specific values, the current manufacturer or supplier specification should override a planning default.

Last reviewed: September 15, 2026, as part of the site-wide calculator workflow validation pass. See the BuildYard Changelog.

COMMON QUESTIONS

Trex-Style Composite Decking Calculator FAQ

What does the Trex-Style Composite Decking Calculator calculate?

It converts the measurements for planning grooved or square-edge composite decking into the buying units normally used for brand-neutral composite deck boards, with the relevant waste, package, weight, or cost outputs shown on the result card.

How accurate is this trex-style composite decking calculator?

The geometry is calculated from the values you enter. Final ordering accuracy still depends on field measurements, supplier density or coverage, product dimensions, compaction, cuts, and the selected allowance.

What should I verify for planning grooved or square-edge composite decking?

This calculator is not affiliated with a manufacturer; use the selected system's board dimensions, approved spans, clips, and installation guide. Confirm the selected product, field conditions, and purchasing increments before placing the order.

Should I round the result up?

Yes for indivisible buying units such as bags, sheets, bundles, pallets, boxes, bars, and truck loads. The calculator rounds those purchase quantities up automatically.

KEEP ESTIMATING

Related decking calculators

All Decking tools

Decking