FREE · PRIVATE · INSTANT

Fence Calculator

Fence Calculator estimates posts, panels, rails, and pickets for general straight-run fence takeoffs. Enter job dimensions in U.S. customary units, adjust supplier assumptions, and get purchase-ready quantities instantly.

Loading calculator…

HOW IT WORKS

Formula and assumptions

Divide the fence run by post and panel spacing, add the terminal post, then estimate rails and pickets by section.

The run is measured along the fence line.
Straight-run quantities exclude special gate and corner assemblies.

FIELD CHECK

Before you order

Divide a site with corners and gates into straight runs; add dedicated corner, end, brace, and gate posts to the order.

Worked example

Example: with fence run 120 ft, maximum post spacing 8 ft, panel / section width 8 ft, rails per section 2, the fence calculator returns 120 lin ft for fence length. The supporting check is posts: 16 posts. Replace the prefilled measurements and supplier assumptions with the project values before ordering.

PROJECT GUIDE

Using this calculator well

WHEN TO USE IT

Best use of this calculator

Use the result as a planning estimate, then verify field measurements and product-specific data before ordering or building.

INPUTS EXPLAINED

What each input means

Fence run: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Maximum post spacing: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Panel / section width: Enter the measured value and choose the matching unit (ft, in, yd, m, cm).
Rails per section: Enter the project value used by the calculation.
Picket width: Enter the measured value and choose the matching unit (in, ft, cm, mm).
Gap between pickets: Enter the measured value and choose the matching unit (in, ft, cm, mm).
Picket waste: Enter the project value in %.
Price per panel / section: Enter the project value in $.

COMMON MISTAKES

Checks that prevent bad estimates

Mixing units or entering a measurement in a different unit than the selected field unit.
Using a planning default when the exact manufacturer or supplier specification is available.
Rounding intermediate measurements too early instead of rounding the final purchase quantity.
Ignoring waste, compaction, cuts, laps, settlement, or full-package rounding where the project requires them.

SOURCES & REVIEW

How this estimate is supported

The implemented formula, assumptions, and worked example on this page are the calculator-specific reference. BuildYard's broader rules are documented in the Calculation Methodology and Sources & References.

For material density, coverage, yield, dimensions, package quantity, price, and other product-specific values, the current manufacturer or supplier specification should override a planning default.

Last reviewed: September 15, 2026, as part of the site-wide calculator workflow validation pass. See the BuildYard Changelog.

COMMON QUESTIONS

Fence Calculator FAQ

What does the Fence Calculator calculate?

It converts the measurements for general straight-run fence takeoffs into the buying units normally used for posts, panels, rails, and pickets, with the relevant waste, package, weight, or cost outputs shown on the result card.

How accurate is this fence calculator?

The geometry is calculated from the values you enter. Final ordering accuracy still depends on field measurements, supplier density or coverage, product dimensions, compaction, cuts, and the selected allowance.

What should I verify for general straight-run fence takeoffs?

Divide a site with corners and gates into straight runs; add dedicated corner, end, brace, and gate posts to the order. Confirm the selected product, field conditions, and purchasing increments before placing the order.

Should I round the result up?

Yes for indivisible buying units such as bags, sheets, bundles, pallets, boxes, bars, and truck loads. The calculator rounds those purchase quantities up automatically.

KEEP ESTIMATING

Related fencing calculators

All Fencing tools

Fencing